What should I pay attention to when customizing LED strips?

Post Excerpt

LED light strips are often used in building decoration, advertising light boxes, jewelry display stands and other constant-light equipment, but what aspects should be considered when customizing LED Strips light?

What should I pay attention to when customizing LED strips?

What should I pay attention to when customizing LED strips?

Because of its high brightness and low energy consumption, LED light strips are often used in building decoration, advertising light boxes, jewelry display stands and other constant-light equipment, but what aspects should be considered when customizing LED Strips light?

1. Look at the solder joints.

 The LED light bar produced by the regular LED light bar manufacturer is produced by SMT chip technology, using solder paste and reflow soldering process. Therefore, the solder joints on the LED light bar are relatively smooth and the amount of solder is small, and the solder joints extend from the FPC pad to the LED electrode in an arc shape. However, the solder joints of the fake version of LED light bars are not uniform, and most of them appear as a dot to cover the solder feet, and at the same time there will be different degrees of tin tips, which is a typical phenomenon of manual soldering.

2. Look at the quality of FPC.

 FPC is divided into two types: copper and rolled copper. The copper foil of the copper-clad board is protruding. If you look closely, it can be seen from the connection between the pad and the FPC. The rolled copper is closely connected with the FPC and can be bent at will without the phenomenon of pad falling off. If the copper-clad board is bent too much, the pad will fall off, and if the temperature is too high during maintenance, the pad will fall off.

3. Look at the cleanliness of the surface of the LED strip.

If the LED light bar produced by SMT process is used, the cleanliness of the surface is very good, and no impurities and stains can be seen. However, if the counterfeit LED light bar is produced by hand soldering process, no matter how it is cleaned, there will be stains and cleaning marks on the surface, and there will be flux and tin residue on the surface of the FPC.

What should I pay attention to when customizing LED strips?

More Insights